Kk2.jpg Apr 2026

: To prepare the motors for flight, move the throttle to zero and the rudder stick to the far right . A red LED or an "Armed" message on the screen will appear.

: Plug your receiver outputs into the left side of the board. Follow the pin definitions for Aileron, Elevator, Throttle, and Rudder. kk2.jpg

This step ensures all motors start at the same time and respond equally to your throttle: : Ensure propellers are OFF . : To prepare the motors for flight, move

: Wait for the ESCs to emit a short beep (full throttle signal), then immediately lower the transmitter throttle to idle. kk2.jpg