Shema Prostejshego Kombika Apr 2026

1kΩ (LED current limiter) and a 10kΩ potentiometer for volume control.

Building your own guitar amplifier (or "kombik") is a classic rite of passage for DIY enthusiasts. The simplest circuits typically focus on small, low-voltage designs that are safe and easy to assemble on a breadboard or perf-board. Core Components of a Simple "Kombik" A standard combo amplifier consists of three main stages:

10µF (gain), 100µF (power filtering), 220µF (output), and a small 0.01µF or 0.1µF capacitor. shema prostejshego kombika

Provides the current needed to drive a speaker. Common ICs for beginner builds include the Go to product viewer dialog for this item. (portable, battery-powered) or the Go to product viewer dialog for this item. .

Boosts the weak signal from the guitar pickups. Simple designs often use a single Go to product viewer dialog for this item. or Go to product viewer dialog for this item. tube to add gain and basic tone controls. 1kΩ (LED current limiter) and a 10kΩ potentiometer

is widely considered the best starting point for a "prosteyshego kombika" due to its minimal part count and ability to run on a 9V battery. IC: low-voltage power amplifier.

1/4" (6.35mm) mono jack for guitar input and an 8-ohm speaker. Assembly Tips Make a Sweet Portable Guitar Amp - Instructables Core Components of a Simple "Kombik" A standard

Usually an 8-ohm speaker housed in the same cabinet as the electronics. Recommended Beginner Circuit: The LM386 "Little Gem" Go to product viewer dialog for this item.