Once the hardware is clear, the printer needs to "learn" its own geometry and load material.

: Most users start with the 3D Benchy boat found on the built-in storage or the included SD card.

Before powering on, ensure all "hidden" shipping materials are removed to avoid mechanical failure.

: Clean the plate with dish soap and water to remove oils, then apply a thin layer of glue stick if using the Cool Plate or Engineering Plate for better adhesion. Load Filament : Place your filament spool on the holder or in the AMS.

: If you have the Combo version, remove the AMS unit from inside the printer and take out any foam pieces under the build plate. Attach Accessories :

The easiest way to verify your setup is to print a pre-sliced file.

: On the touchscreen, go to Utilities > Calibrate . This will perform bed leveling, resonance testing, and vibration compensation.